Greasing your garage door is important for a number of reasons. It stops any awful screeching noises and prevents rust build-up, so the moving parts of your door keep working for longer. It will also help you avoid problems with a door that sticks.
Unfortunately, many people don't know where to start with garage grease and they make mistakes that can actually cause more problems than they solve. These Dos and Don'ts for greasing a garage door will help you avoid any disasters when maintaining your Garage doors.
Do's For Greasing a Garage Door
When greasing your door, you should always use a specific garage grease that is lithium-based. Don’t be tempted to use WD-40 because it is a degreaser, so it will actually remove lubrication and make the problem worse.
Remember to always read the manufacturer's instructions on the garage door and the grease can before using it. Some garage doors need special oils and others require different quantities of oil than what the instructions state. Failure to read the instructions properly could result in permanent damage to your door.
Keep all pets and children away from the door while you are working. The ingredients in garage grease can be toxic if ingested, so this is very important.
Once the area is prepared, you can start greasing the garage door. The key areas you need to focus on are:
Hinges - Close the door and spray a small amount of garage grease into the hinges. There should be around nine hinges. When finished, open and close the door a few times to spread the grease.
Ball Bearings - The tracks from the floor to the ceiling on either side of the door contain ball bearings. These need to be lubricated but be careful not to spray too much on the tracks themselves.
Top Of The Rail - The rail that runs along the top of the door should be lubricated to prevent rust. Spray some onto a cloth and run it over the rail.
The Spring - If the spring is free hanging, it is an extension spring that most likely already has a rust protection coating, but you still need to lubricate the ball bearings. If the spring is wound around a metal bar, it is a torsion spring and the entire thing needs to be lubricated.
The Lock - If your garage door has a lock, spray the keyhole to stop it from rusting.
Once you have finished greasing the doors, you need to clean the tracks to remove excess lubricant.
Don'ts for Greasing a Garage Door
There are a few common mistakes you must avoid when greasing your garage doors. Firstly, make sure that you only use lithium-based grease and avoid anything else.
It is also important to avoid getting too much grease on the tracks themselves. If you have nylon rollers instead of metal ball bearings, you need to call in a specialist because standard garage grease can cause damage.
Don’t neglect greasing, especially when the weather is cold. Ideally, you should grease your garage every six months to keep it in good condition.
If you are having trouble with your garage doors in Mattoon, IL, call in a professional garage door supplier to make repairs or replace the door, if necessary.